Digital Read Outs

Shown with 6 axes motion board, Provided 24V power supply, Solid State OPTO 22 relay, terminal strip, 25 & 9 pin extra ribbon cables, and 100 pin shielded mylar cable

Turn your PC into a "DRO" Digital Axes Read Outs

Hardware and Software starting under $1,000

(encoders or scales required)

(Windows XP or higher required)

• Up to 6 linear or rotary axes
• Mill or Lathe Interface
• Measure Distances
• Find Angles
• Pop up Calculator
• Metric, Inch or Degree mode
• Preset or reset any axis position
• Built in I/O Home and Over Travel relays with lights
• 26 I/O and Analog Output +/- 10V
• Turn on/off your spindle
• Vary Spindle RPM
  (spindle drive or VFD required)